This month I got called to a bedroom in Morganton where a receptacle had nearly started a fire. It was right under the homeowner's headboard. The outlet was an old 2-prong receptacle with a 2-to-3 prong adapter plugged into it. A surge protector with a long cord was plugged into the adapter, and a space heater was plugged into that. The adapter melted, the receptacle burned, and the wall above it was scorched black.

Burned 2-prong bedroom receptacle and scorched wall from an overloaded space heater setup in Morganton, NC

Melted 2-to-3 prong adapter removed from a burned receptacle in Morganton, NC

Why space heaters are hard on outlets

Most space heaters pull close to 1,500 watts, about 12 to 13 amps, for hours at a time. That's close to the limit of a standard 15-amp circuit. Every connection between the heater and your wiring has to carry that load: the plug, any adapter, any power strip, and the receptacle itself. If any of those connections is loose or worn, it heats up. Old receptacles lose their grip on plugs over the years, and that's when things start to melt.

Melted adapter and surge protector plug from a space heater overload in Morganton, NC

Space heater do's and don'ts

  • Plug the heater directly into a wall outlet. Never use an extension cord, power strip, surge protector or adapter.
  • Don't run other big loads on the same circuit while the heater is on.
  • Keep it 3 feet from beds, curtains, furniture and anything that can burn.
  • Use a heater with tip-over and overheat shutoff, and turn it off when you leave the room or go to sleep.
  • Check the plug and outlet now and then. If either feels hot, looks discolored or smells like burning plastic, stop using it.

Warning signs your outlets need attention

  • 2-prong outlets with no ground
  • Plugs that fall out or feel loose
  • Warm or discolored cover plates
  • Breakers that trip when the heater runs
  • Flickering lights when the heater kicks on

What I did on this job

I replaced the burned receptacle with a new GFCI receptacle, which adds shock protection on an older 2-wire circuit. If you have older wiring, ask me about arc-fault protection too. It's designed to catch damaged or loose connections that are arcing, which is how a lot of electrical fires start.

If you rely on space heaters, or if any of your outlets look like this, call me at (828) 610-1894. I serve Morganton, Hickory, Lenoir and the rest of the Catawba Valley. You can also read my winter electrical readiness checklist.